Vacuum hose adapter, made to your two sizes, 3D printed in PLA

Vacuum hose adapter, made to your two sizes

Joins a shop vac hose to a tool's dust port, or any two round ends, made to the two sizes you measure.

Customize
mm
First end fits
mm
Second end fits

$10.92

Delivered. Ships in 3-5 days.

Material
Color
PLA, Black

Shipping $5.51

Price breakdown
Print, PLA 31.2 g, 51 min
$5.41
USPS Ground Advantage
$5.51
Total, before tax
$10.92

69 × 69 × 74.3 mm

Up to 20 parts in one order, one shipping charge.

Customize more in the AI designer: change the shape, add holes or sizes, then order the same way.

What it's for

Your vac hose and your sander were never sized to each other. Measure both ends, enter the two numbers, and the adapter is made to them, so you can stop taping hoses together. Shop vac hoses are usually 1-1/4 in (31.75 mm), 1-7/8 in (47.6 mm) or 2-1/2 in (63.5 mm), and dust ports on sanders, saws and routers run anywhere from about 25 to 100 mm, so measure rather than trust the label.

For each end, pick how it joins. Over it: the adapter slides over a hose cuff or a dust port, so measure that part's outside with calipers. Into it: the adapter pushes into a hose or a port, so measure its inside. Each end is 30 mm deep and tapers 0.5 mm, so it goes on by hand and gets snug as you push. The walls are 2.4 mm.

PLA is fine for a vac, a sander or a saw in the shop. Pick PETG for a hot garage, an adapter in the sun, or one that gets knocked around on the floor. For a bend, a blast gate, a square port or more than two ends, use Customize more.

Sizes and price

Each end
15-105 mm, over or into its part
Depth
30 mm per end, 0.5 mm taper
Walls
2.4 mm
Common hose sizes
1-1/4, 1-7/8 and 2-1/2 in
As shown
69 × 69 × 74.3 mm
Material
PLA in black, white, gray, red, blue, green; or PETG in black or white (made to order, +20%, 3 to 5 extra business days)
Price as shown
$10.92 delivered
Four of them
$17.33 delivered

Prices include USPS Ground Advantage shipping anywhere in the US; sales tax is added at checkout where required. A different size or text changes the price; the panel above shows it before you order.

Questions

Which diameter do I measure?

For an end that slides over something, measure that part's outside. For an end that pushes into something, measure its inside. Calipers give the best number; a ruler across the end is close for anything over 40 mm.

My hose says 2-1/2 inch. Is that the inside or the outside?

Usually the inside of the hose, and the cuff at its end is a different size again. Measure the part the adapter will actually touch.

Will it be airtight?

Tight enough for a shop vac on a sander or saw: the taper seats each end as you push. If one end is loose or out of round, a wrap of electrical tape seals it.

Can both ends be the same size?

Yes. Over on one end and into on the other joins a hose to a hose, or makes a male end out of a female one.

More in How to Measure a 3D Object for Printing: Calipers and Clearance and 3D Printing Tolerances: Clearance for Press, Snug and Sliding Fits.