
Round tube end caps, made to your tube
A cap that pushes over a round tube or leg, or a plug that pushes inside it, with crush ribs sized to your diameter.
$9.40
Delivered. Ships in 3-5 days.
Shipping $5.51
Price breakdown
- Print, PLA 5.2 g, 16 min
- $3.89
- USPS Ground Advantage
- $5.51
- Total, before tax
- $9.40
30.6 × 30.6 × 18 mm
Up to 20 parts in one order, one shipping charge.
Customize more in the AI designer: change the shape, add holes or sizes, then order the same way.
What it's for
Missing a cap on a chair leg, a rail or a frame? Hardware stores carry a handful of sizes, and the one you need is never among them. Measure the tube, enter the number, and the cap is made to it: eight crush ribs inside grip the tube, so it pushes on by hand and stays put.
Over the tube: measure the outside diameter with calipers. The cap goes over the end like a boot, with a 3 mm closed end, good for chair and table legs. Inside the tube: measure the inside diameter. The plug has a flange 6 mm wider than the hole that covers the tube's wall, for open tube ends on rails and frames. Depth is how far it goes on or in.
PLA is hard and slides on most floors. For legs that get dragged a lot, or a cap in a hot car or garage, pick PETG. Round tubes only; for square or oval tubes use Customize more.
Sizes and price
- Tube diameter
- 8-50 mm, outside or inside
- Depth
- 6-30 mm
- Closed end
- 3 mm, or a flange 6 mm wider than the hole
- Grip
- 8 crush ribs
- As shown
- 30.6 × 30.6 × 18 mm
- Material
- PLA in black, white, gray, red, blue, green; or PETG in black or white (made to order, +20%, 3 to 5 extra business days)
- Price as shown
- $9.40 delivered
- Four of them
- $10.57 delivered
Prices include USPS Ground Advantage shipping anywhere in the US; sales tax is added at checkout where required. A different size or text changes the price; the panel above shows it before you order.
Questions
Which diameter do I measure?
For a cap over the tube, the outside diameter. For a plug inside the tube, the inside diameter. Calipers give the best number; a ruler across the end is close enough for an outside cap on a leg 20 mm or wider.
How tight is the fit?
Snug enough to push on by hand and stay put. The ribs are sized to your number and give a little as they go on. If a tube is out of round or painted thick, a tap with a rubber mallet seats it.
Do they work on square tubes?
No, these are round. For a square or rectangular tube, use Customize more and give the size, or ask us.
Will they protect my floor?
They cover a bare metal or cut edge, which is what scratches. PLA is hard plastic, not felt or rubber; for wood floors, stick a felt pad on the bottom of the cap.
More in 3D Printing Tolerances: Clearance for Press, Snug and Sliding Fits and How to Measure a 3D Object for Printing: Calipers and Clearance.


